Description

Send Inquiry

Mains Power Optical Heat Detector manufacturer

Thanks to its advanced technology, the Mains Power Optical Heat Detector can detect even the slightest smoke or heat in the environment, thus providing early warnings in case of a fire outbreak.

Mains Power Optical Heat Detector is that it is very easy to install. With a few tools, anyone can install it within minutes without professional assistance. The detector is designed to be compatible with almost every electrical system, making installation a breeze.

Custom Service: Accept ODM/OEM Service

Professional Team

Operation and Testing:

TESTING:

Test by pushing the test button on the cover. This will sound the alarm if the electronic circuitry, alarm, and battery are working. If no alarm sounds, the unit has defective batteries or other failures.

DO NOT use an open flame to test your alarm, you could damage the alarm or ignite combustible materials and start a structure fire.

NOTE: WEEKLY TESTING IS REQUIRED

Normal Condition

The green LED light is always on and the red LED should flash every 40 seconds to show that the alarm is active.

Alarm Condition

When the Alarm senses products of combustion and sounds the audible alarm, the red LED will flash one flash/second. The flashing LED and pulsating alarm will continue until the air is cleared.

Low Power Pack Condition

IMPORTANT: Your smoke alarm requires the power pack (9v DC battery) to have sufficient capacity of power to operate correctly.

Should your smoke alarm enter a low power pack condition, the unit will emit an audible chirp once every 40 seconds. When this occurs, you must replace the battery immediately. Your smoke alarm will continue to warn of this low power pack condition for approximately 7 days, however, failure to change the battery after this time would mean your smoke alarm may have insufficient power to alert you in a real fire situation. After the battery is replaced, the low power warning chirp will stop.

20240102111917